|
Sensicool Controller
Salient Features
- Controls two air conditioners.
- Separate Phase Supply for each A/C.
- Bright Red 4 Digit LED Display
- Accurate Temperature sensing by precise temperature sensor.
- Time Sharing for Compressors to share load equally.
- Voltage & Current protections for each compressor.
- Separate alarm relay contacts forAC Fail.
- Fire protection by Digital Input
- Hour counters for Compressor ON Period to check its reliability.
- Display of all the A/C parameters & fault messages continuously in a scrolling manner
- Display Hold Feature by using ENTER Key. Press it again to release the hold.
- Various set points are settable through the following different Menu categories: a] VIEW b] SET c]RESET
- Password Protection for all the settings.
- Sensor Fail Mode to keep ON & OFF cycle of one of the A/C through sensor fail ON/FF time settings.
- Auto (with all protections)/Manual (without protection) Modes.
- Controller Bypass feature by provision of Switch on Front Panel.
- LED Indications to observe the status.
|
1]Supply Voltage :
|
230 VAC, 50 Hz +/- 15% separate for each A/C.
|
|
2] Contact Rating:
|
30 Aat 230 VACfor CompressorLive Outputs&
5 A at 250 VAC for AlarmPotential FreeOutputs(C,N/O)
|
|
3] Temperature Sensor:
|
Thermistor Sensor NTC 10K@25ºC Metal body with clamp.
Sensor Cable Length: 2.75 meters
|
|
4] Temperature Sensing Range:
|
0.0º º C to 55.C
|
|
5] Resolution :
|
1V for Voltage, 0.1 A for Current & 0.1ºC for temperature.
|
|
6] Auto/Controller Bypass Switch:
|
To bypass the controller i.e. A/C1 &A/C2 will remain ON
continuously if both the switches are in ON condition.
|
|
7] Indications:
|
1] SupplyON for A/C1 &A/C2. Colour: Yellow
2] Auto Mode for A/C1 &A/C2 Colour: Green
3] Manual Mode for A/C1 &A/C2 Colour: Red
4] AC ON for A/C1 &A/C2 Colour: Green
5] Fault for for A/C1 &A/C2 Colour: Red
6] Room High Colour: Red
7] Healthy Colour: Green
|
|
8] Keys: 4 key keypad for settings.
|
1] SET Key: To enter into SET Mode/To view the next set point
2] Up Arrow Key : To increment the set point/To view next menu/To view next set point inVEW menu.
3] Down Arrow Key: To decrement the set point/To view previous menu/To view previous set point in VEW menu.
4] ENTER Key: To come out of SET mode/To enter into menu/To accept the password
|
|
9] Mounting :
|
Flush mounting
|
|
